POK, full catalogue English

174 POK SAS - 18 Cours Antoine Lavoisier - 10400 Nogent-sur-Seine - FRANCE Phone: +33 (0)3 37 49 53 - 000 - Email: export@pok-fire.com - Web: www.pok-fire.com V2 Elevator control box POK elevators are designed to work with most of our fixed monitors. The control box guarantees safe use of the elevator. - The upper and lower limit switches automatically stops of the movements when the elevator reaches its maximum or minimum position. - In case of failure of the limit switches, a current measurement allows to stop the movement when the elevator reaches its maximum or minimum position. - Signalling LED placed on the electronic board provide the elevators present operational status and allow to troubleshoot it easily. - Finally, electromechanical relays provide galvanic isolation between the elevator powering and the control electronics. Power supply 24 V + - Designation Ref. V2 elevator control box TC010258 Box dimensions: 220 x 120 x 81 mm Transmitter weight: 1,94 Kg Waterproofing: IP66 Operating temperature: -30°C to +65°C Power supply: 24 VDC - Consommation < 100 mA Monitor - Remote control systems Li-Ion battery charger Equipped with all safety features (short-circuiting, over-voltage, overloading, polarity reversing), this charger allows you to charge the Li-Ion batteries of all STACS and STACS Lite compatible monitor with complete peace of mind. Particularly intelligent, the charge is done in 3 steps, pre-charge, slow charge at stable current and then charge at stable voltage, thus guaranteeing a battery life of more than 1000 cycles; a led indicator allows to visualize the state of the charge in progress. Equipped with an output cable with a connector, the charger connects directly to the battery. Thanks to its technology, it can be connected to all supply networks without any adaptation. Input voltage: 100 to 240 VAC - 50to 60 Hz - 1.8 A Power consumption: < 2.0 W without charge Input current at full load: < 1.8A Nominal output voltage: 24V Maximal output voltage: 29.2 V +/- 0.25 V Output current: 2 A +/- 0.2 A Efficiency: > 80% Ripple: < 1% of the output voltage Protection Short-circuit, over-voltage, overload, reverse polarity Dimensions: 120 x 60 x 30 mm Weight: 280 g Charging in 3 steps: pre charge, constant current charge, constant voltage charge Charging time: under 5 h Operating temperature: 0 to +40°C Storage temperature: -20°C to +60°C Humidity: < 65% Connectors: BINDER 6-contact male plug ref. 99-5622-15-06 Length of the output cable: 25 cm +/- 1 cm Wiring: 1/NC, 2/NC, 3/+ Charge, 4/- Charge, 5/NC, 6/NC Red LED: Charge in progress Green LED: Full charge or no battery connected Designation Ref. Li-Ion battery charger 28188